All KUTAVAR Machines are highly configurable for your needs, with a range of optional extras and upgrades available to be installed from new, or at a later date.
BOGE S eco DR Compressor
A super-silenced, oil-lubricated rotary screw-type air compressor with a refrigerant dryer. Features include a 400V, 7.5 KW / 10 HP motor, with effective free air delivery of 1 m3/min, and a 250 litre condense trap.
Manufactured in Germany and, when installed by an approved BOGE installer, has a warranty period of up to 10 years.
Engraving Head
The engraving device allows operators to scribe cut part numbers, identification tags, logos and illustrations into your sheet material.
It streamlines the process of marking and preparing materials while guaranteeing precision and consistency in the final product.
The pneumatically powered engraver retracts when not in use, protecting it from the environment.
Kemper PlasmaFil Extractor
A central extraction and filtration system, designed to capture both smoke and dust particles, and recirculate clean air.
The unit is standalone and is especially suited when ductwork through an exterior wall is not practical.
The unit comes installed with KemTex® ePTFE membrane filter cartridges, designed to capture and separate ultra-fine dust particles below 0.1 µm (0.1 microns).
HVAC Slats
The slats are designed for when increased contact is necessary between thin sheet material and the table itself.
Limiting the degree of sheet material deflection following heat distortion generated from the plasma power source, provides greater stability for the material, maximising cut quality and yield.
Oxy-fuel Cutting Head
Available with all KUTAVAR zoned-extraction tables is the option of cutting with Oxy-fuel. A simple manual changeover allows the operator to swap from the plasma torch to the gas torch in seconds.
The Oxy-fuel cutting head is paired with our raised gantry, allowing for the cutting of a fully-sized metal sheet up to 100mm thick.
Power Source Upgrades
KUTAVAR Machines are manufactured to work with all Hypertherm Power Sources, from the single-phase 45 A Powermax Series to the high-definition XPR Range.
Should your cutting requirements change, please contact us to discuss your power source.
To discuss your KUTAVAR Upgrades and Extras, contact the team on +44 (0)1432 805700.
